Rate Limiting in Nginx

Adding Rate Limiting to the Server

Nginx provides a simple way to add rate limiting using the limit_req_zone and limit_req directives.

Edit the main configuration file to define a rate limit zone:

Terminal window
```
sudo nano /etc/nginx/nginx.conf
```
Add the following to the http block:
```
http {    limit_req_zone $binary_remote_addr zone=mylimit:10m rate=2r/s;
    ...}
```
The directive limit_req_zone is used in Nginx to define a shared memory zone that will be used to store the state of rate limits for incoming requests. Here’s a breakdown of the specific directive you provided:
```
limit_req_zone $binary_remote_addr zone=mylimit:10m rate=2r/s;
```
- $binary_remote_addr: This is a variable that holds the client’s IP address in a binary format. Using the binary format saves memory, which is important when dealing with large numbers of requests.
- zone=mylimit:10m: This specifies the name and size of the shared memory zone used to store the state of rate limits.
- mylimit is the name of the zone.
- 10m means that the size of the zone is 10 megabytes. This size dictates how many IP addresses and their request states can be stored in memory. A 10MB zone can typically store about 160,000 states (given that each state takes about 64 bytes).
- rate=2r/s: This sets the request rate limit.
- 2r/s means that each IP address is allowed to make 2 requests per second.
When you configure limit_req_zone in your Nginx configuration, it sets up a system to control how many requests a client can make to your server in a given time frame. This can help protect your server from being overwhelmed by too many requests from a single client, which can be a form of denial-of-service attack.
Edit your server block configuration to apply the rate limit:

Terminal window
```
sudo nano /etc/nginx/sites-available/default
```
Add the following inside the server block:
```
server {    ...
    location / {        limit_req zone=mylimit burst=20 nodelay;        try_files $uri $uri/ =404;    }
    ...}
```
- limit_req zone=mylimit burst=20 nodelay;: This applies the rate limiting defined by the mylimit zone.
- burst=20 allows a burst of up to 20 requests beyond the defined rate. So, even if the rate limit is set to 2 requests per second, the burst allows up to 20 requests to be made in a second. The requests exceeding the rate limit will be rejected immediately.
- nodelay means that requests that exceed the rate limit should be rejected immediately rather than delayed.

Test and reload Nginx:

Terminal window

sudo nginx -tsudo systemctl reload nginx

Previous
Nginx Ubuntu Setup Next
Deploy Node API and reverse proxy